Basic questions on networks, RC and RL circuits with voltage sources, current sources, diodes, ideal opamps etc.
Analog Design Interview Questions
789 analog design interview questions shared by candidates
A resistor and capacitor circuit and asked me the current going through a particular branch as a function of time. Looked complicated at first but was a simple application of KCL.
Read RC circuit Fourier Series ,Mos Basics ,Filters, OPamps.
They basically asked about question related to RC and LC circuit ,op amps related questions. Questions relation to bode plot and lead lag compensator. there were also question related to CMOS circuits and seconds order equation relating network analysis
Start up circuit of a BGR ? ( from masters project)
The interviewer started with basic step response of low pass RC circuits. Then went on adding resistors and capacitors to the circuit. Then he told me to analyse an opamp circuit with step input. Then he went to bode plot of a first order transfer function. He asked why the transfer function does not blow up at a pole in the bode plot.
Basics of Operational Amplifier,VLSI,RLCand Analog Integrated Circuits.
General 1st order and 2nd order circuits. Basics of mosfet and BJT
Questions were from device physics, Analog Design basics like a current mirror, charge pump, LC-VCO, lumped components based circuits, Analog layout, PVT variations effects on basic analog blocks, so on, mostly from my previous work experience.
Mostly discussed the Internship and projects
Viewing 471 - 480 interview questions